FBMSVL 电液伺服卡现场总线段之间也有电流隔离，从而防止多段接地故障导致多段故障。每个段都有自己的现场总线功率调节器和电流限制。当安装单个或冗余F80x模块时，现场总线段的终端自动保持。AnF809F- -Plus诊断模块可选择安装在载体上，自动收集和分发八个现场总线段的诊断信息。通过将F809F-Plus作为现场总线设备分配给1段或8段供电段，或通过单独的现场总线段，可在Foxborocontro|系统中查看测量参数。 基板上提供了独立段的连接。有关更多信息，请参见F809F-Plus产品规格。冗余24V DC(标称。)输入电源可以使用Foxboro |/a标准放大器连接器连接到F810底板。F80x电源模块和F809F-Plus现场总线诊断模块可以由洞一个电源供电，或者，对于标准Foxboro电源不能提供足够电流容量的装置，可以连接外部24V DC电源。现场接线连接可采用可插拔螺钉端子(F810-PS)或可插拔弹簧夹端子(F810-PC)。
There is also current isolation between the on-site bus sections to prevent multiple ground faults from leading to multiple faults. Each segment has its own fieldbus power regulator and current limit. When installing a single or redundant F80x module, the terminal of the on-site bus section is automatically maintained. The AnF809F Plus diagnostic module can be optionally installed on the carrier, automatically collecting and distributing diagnostic information for eight on-site bus sections. The measurement parameters can be viewed in the Foxborocontro | system by assigning the F809F-Plus as a fieldbus device to either 1 or 8 power supply segments, or through a separate fieldbus segment. Independent section connections are provided on the substrate. For more information, please refer to the F809F-Plus product specifications. Redundant 24V DC (nominal.) input power can be connected to the F810 backplane using Foxboro |/a standard amplifier connectors. The F80x power module and F809F-Plus fieldbus diagnostic module can be powered by a single power supply, or for devices where the standard Foxboro power supply cannot provide sufficient current capacity, an external 24V DC power supply can be connected. The on-site wiring connection can use pluggable screw terminals (F810-PS) or pluggable spring clip terminals (F810-PC).
扫一扫咨询微信客服
