GE    IC698PSA350E 电源模块 它还将逻辑电平排序信号发送到背板上的模块

IC698PSA350E   电源模块

IC698PSA350是GE Fanuc为RX7i系列生产的PACSystems电源模块。该模块提供 +5 VDC、+12 VDC 和 -12 VDC 电源。此外，它还将逻辑电平排序信号发送到背板上的模块。模块插入主机架的插槽 0。IC698PSA350模块的电源输出可能会丢失一个交流输入线路周期，同时保持输出功率。除了电子短路保护外，还提供过流和过压故障保护。该模块可在 100 至 0ºC 的环境温度下提供 60 瓦的总输出功率，无需强制风冷。输出电压如下：+5 VDC 输出至 60 安培，+12 VDC 输出至 12 安培，-12 VDC 输出至 4 安培。IC698PSA350模块更显著的特点包括工作电压范围为 85 至 264 VAC 或 100 至 150 VDC。该模块配备交流操作功率因数校正和简单的滑入式机架安装结构。两位开/关逻辑电平开关位于前面板上。它具有启用或禁用输出通道的能力，并且不会干扰交流线路输入。重要警告：当存在输入电源时，模块中存在致命电压。IC698PSA350模块上的绿色 LED 指示灯监控现场和输出的状态。当在可接受的范围内通电并且直流输出通道正常工作时，这些通道将打开。特定于此模块的红色 LED 将在关键供应温度过高或气流出现问题时提醒用户。

IC698PSA350 is a PACSystems power module produced by GE Fanuc for the RX7i series. This module provides+5 VDC,+12 VDC, and -12 VDC power supplies. In addition, it also sends logic level sorting signals to modules on the backplane. Insert the module into slot 0 of the mainframe. The power output of the IC698PSA350 module may lose one AC input line cycle while maintaining output power. In addition to electronic short circuit protection, it also provides overcurrent and overvoltage fault protection. This module can provide a total output power of 60 watts at an ambient temperature of 100 to 0 º C, without the need for forced air cooling. The output voltage is as follows:+5 VDC output to 60 amperes,+12 VDC output to 12 amperes, and -12 VDC output to 4 amperes. The more prominent features of the IC698PSA350 module include a working voltage range of 85 to 264 VAC or 100 to 150 VDC. This module is equipped with AC operated power factor correction and a simple sliding in rack mounting structure. The two position on/off logic level switch is located on the front panel. It has the ability to enable or disable output channels and does not interfere with AC line inputs. Important warning: When there is an input power supply, there is a fatal voltage present in the module. The green LED indicator light on the IC698PSA350 module monitors the status of the field and output. When powered within an acceptable range and the DC output channels are functioning properly, these channels will open. The red LED specific to this module will alert users when critical supply temperatures are too high or airflow issues occur.