GE IC693MDL753H 正逻辑输出模块 每组输出点可以驱动不同的负载

IC693MDL753H    正逻辑输出模块

GE Fanuc IC693MDL753是 12/24 伏直流电、0.5A 正逻辑输出模块。 该输出模块专为 90-30 系列可编程逻辑控制器而设计，配备 32 个离散输出。这些产出分为四个独立的八组。每个组都有自己的专用共同点。当它们提供类型输出时，它们切换电源正极的负载，为负载提供电流。该模块的输出能够在 +12 至 +24 VDC （+20%， –15%） 范围内切换负载。它们还可以将电流源到每点 0.5 安培的大值。在组公共资源中，有用户 I/O 连接器。每个连接器有两个引脚，可处理高达3A的电流。当用户连接组公共时，建议连接到两个引脚。

每组输出点可以驱动不同的负载，但是用户必须提供外部电源才能实现这一点。该模块上有光耦合器，可在现场侧和逻辑侧之间提供背板隔离。 与GE Fanuc的许多其他输出模块一样，该模块与90-30系列PLC系统兼容。要实现它，用户可以将其安装在底板的任何I / O插槽中。 在模块的正面，有两个 24 针公连接器。这些允许连接到用户负载设备。输出组 A 和 B 具有由右侧连接器提供的接口，而组 C 和 D 使用左侧的连接器。

GE Fanuc IC693MDL753 is a 12/24V DC, 0.5A positive logic output module. This output module is designed specifically for the 90-30 series programmable logic controllers and is equipped with 32 discrete outputs. These outputs are divided into four independent eight groups. Each group has its own dedicated commonalities. When they provide type output, they switch the load of the positive pole of the power supply to provide current to the load. The output of this module can switch loads within the range of+12 to+24 VDC (+20%, -15%). They can also source current to a maximum value of 0.5 amperes per point. In the group common resource, there are user I/O connectors. Each connector has two pins and can handle currents up to 3A. It is recommended to connect to two pins when the user is connected to a common group.
Each set of output points can drive different loads, but users must provide external power to achieve this. This module has an optocoupler that provides backplane isolation between the field side and the logic side. Like many other output modules of GE Fanuc, this module is compatible with the 90-30 series PLC system. To implement it, users can install it in any I/O slot on the backplane. On the front of the module, there are two 24-pin male connectors. These allow connection to user load devices. Output groups A and B have interfaces provided by the right connector, while groups C and D use the left connector.